Sep. 25, 2019
The roll forming machine firstly aligns the four corners of the front and rear queues of the color steel tile press machine from the upper end of the big frame to the upper end of the shaft, and then from the first row to the last row, find a wire straightened, check it. Whether the lower shaft is on a straight line, and the left and right sides of the lower shaft are adjusted to be horizontal. In the left and right sides of the cabinet, a lubrication pump is installed, and the machine passes through the oil pipe to convey the lubricating oil to each friction moving part.
The roll forming machine is a hydraulic press used for the precise determination of the rough blanks extruded and cut by the vacuum screw extruder when the glazed tile is wetly produced. The automatic roll forming machine can be installed separately, but requires manual loading. Blanks, unloading blanks, and can also be equipped with automatic loading racks and unloading robots and extruders, cutting machines, blanking machines and Watt conveyor lines to form the production line of the brick blank, completely without manual operation.
Rolling forming machine manual discharging, reclaiming work procedure: Before using the equipment, check whether the connection is firm, whether the mounting bolts and nuts are tightened, and the lubricating oil should be added to the left and right chassis to start the machine for commissioning.
Observe the empty car operation carefully, whether there is vibration, noise, whether the oil window comes to the oil, whether the movement of each component is coordinated, and the mold can be installed after everything is normal. When installing the mold, the power must be cut off, and the motor belt or the large gear should be manually moved. The table is indexed, and the slide is raised to the point, and is supported by an object between the workbench and the bottom surface of the slide, so that the anti-slip seat naturally falls, causing an accident.
Failure analysis of the roll forming machine:
The failure analysis of the roll forming machine equipment is also called fault judgment. It analyzes the cause of the fault from the investigation of the fault, proposes the method of troubleshooting, and explores the process of mitigating and delaying the fault occurrence. Generally, there are data collection, comprehensive, Analysis, fault judgment, effect record and other steps.
Incorporate and sort out the data obtained from the survey, go to the rough and extract the essence, go to the false and true, grasp the main problems, comprehensively analyze, analyze and reason, find one or two of the most important substantive symptoms, and reason for the occurrence of the fault, and also Pay attention to latent faults that are not related to the current fault.
