Dec. 26, 2020
In the working process of the tile press, due to improper operation, it is inevitable that this or that situation will occur, in which the cutter of the tile press will not move when it is working. When the cutter of tile pressing machine fails to cut, it is most likely caused by insufficient pressure. When this happens, the first thing to check is whether the pressure gauge can be fixed. The voltmeter shows that the voltage above 200V is normal, and the voltage below 200V is mostly zero line fault. The knife keeps going down and holding the oil pump
1. The lower limit is not adjusted properly or the switch is damaged.
2. The solenoid valve is stuck. Turn off the oil pump, press the knife to lift and drop respectively. When the sound of "snap" can be heard, turn on the oil pump and raise the knife to the upper limit.
a. The mold keeps going up, holding the oil pump:
(1) Improper adjustment or damage of upper limit switch position;
(2) K3 and K4 are connected reversely;
(3) When the solenoid valve is stuck, turn off the oil pump, press the mold up and down respectively, and when the "snap" sound can be heard, turn on the oil pump to raise the mold to the upper limit.
b. Manual normal, no automatic:
(1) The manual automatic button is not in the automatic position or damaged, and the start button is damaged;
(2) The knife is not connected reversely at the upper or lower limit position;
(3) The die is not connected reversely at the upper or lower limit position;
(4) Data setting error.
There are many reasons for the cutter of tile press not working normally. The staff should judge the cause of the problem according to the specific situation, so as to solve the problem quickly.
