Dec. 11, 2019
Maintenance contents of hydraulic part of composite board machine equipment:
I. hydraulic oil circuit of composite board machine
1. Check the oil level of the oil tank every week. If the oil level is lower than the oil window, fill in the hydraulic oil;
2. The system oil temperature shall be between 35 ℃ - 60 ℃, and shall not exceed 70 ℃. If it is too high, the oil quality and accessories will be damaged
3. The hydraulic oil used in this machine is isohm46 or mobildte25;
4. The oil shall be changed after the new machine works for 2000 hours, and after every 4000-6000 hours, the oil shall be changed, and the oil tank shall be cleaned every time;
II. Composite plate machine filter
1. The filter shall be replaced or thoroughly cleaned each time the oil is changed;
2. If the machine tool has related alarm or other filter abnormalities such as unclean oil quality, it should be replaced;
3. The air filter on the oil tank shall be inspected and cleaned every three months and replaced every year
III. hydraulic components of composite board machine
1. Clean the hydraulic components (baseplate, valve, motor, pump, oil pipe, etc.) monthly to prevent dirt from entering the system, and do not use detergent;
2. After the new engine has been used for one month, check whether there is any deformation at the bend of each oil pipe. If there is any abnormality, replace it. After two months of use, fasten the connection of all accessories. When doing this work, shut down the engine, and the system is free of pressure
