Apr. 09, 2020
The split or block installation method of the composite board molding machineThe split or block installation method refers to dividing the grid into strips or block units, which are hoisted by the lifting equipment to the high-altitude design position and placed in place, and then installed as a whole method.
Strip refers to the segmentation along the long span of the grid, and the width of each segment can be from one grid to three grids, the length of which is the span of the short span of the grid. Block refers to the segmentation along the vertical and horizontal directions of the grid The shape of the rear unit is rectangular or square. The weight of each unit of the composite plate tile press is based on the lifting capacity of the existing lifting equipment on site.
The multi-section welding or splicing installation method of the composite board molding machine machine is carried out on the ground, which is conducive to improving the quality of the project and can save most of the assembled brackets. The existing lifting equipment on the site has been considered because of the single division Ability to make full use of the existing equipment on the construction site and reduce the rental cost of lifting equipment. The high-altitude bulk method of the composite board machine refers to the small unit or part (single rod and single node) directly at the design location The total fight method.
The high-altitude bulk method of the composite board forming machine has two types: the full bracket (that is, the full scaffolding) method and the cantilever method. The full bracket method is mostly used for assembling parts, and the cantilever method is mostly used for the assembly of small units at high altitude. High-altitude assembly does not require large-scale lifting equipment, but due to the large-scale assembly bracket, a large amount of scaffolding materials are required.
